For Furnace repair in Pikesville MD, like us on Facebook!
For Furnace repair in Owings Mills MD, visit us on Google!
To schedule your Boiler installation in Baltimore MD, just email us!
Furnace repair  in Pikesville MD

Your Heating & AC Expert in the Greater Baltimore Area

Installing Insulation on an Electric Hot Water Heater

 
 
For Furnace repair in Pikesville MD, like us on Facebook!
For Furnace repair in Owings Mills MD, visit us on Google!
To schedule your Boiler installation in Baltimore MD, just email us!
Furnace repair  in Pikesville MD

Installing Insulation on an Electric Hot Water Heater

Installing an Insulation Blanket on an Electric Water Heater

Note: Installation is more difficult on gas and oil-fired heaters. Ask a qualified HVAC contractor for instructions.

  1. Cut the tank top insulation to fit around the piping at the top of the tank. Tape the cut section closed after the top has been installed.
  2. Fold the corners of the tank top insulation down and tape to the sides of the tank.
  3. Position the insulating blanket around the circumference of the tank. For ease of installation, position the blanket so that the ends do not come together over the access panels in the side of the tank. Some tanks have only one access panel.
  4. Secure the blanket in place with the belts provided. Position the belts so they do not go over the access panels. Belts should fit snugly over the blanket but not compress it more than 15% to 20% of its thickness. The installation is easier with two people. If working alone, use tape to hold the blanket to the top until you get the belts into position.
  5. If your water heater has the temperature/pressure relief valve and the overflow pipe on the side of the tank instead of on the top, install the blanket so these items are outside of the blanket. Depending on the piping arrangement and location, you may need to compress, or even cut, the blanket.
  6. Locate the four corners of the access panel(s). Make an x-shaped cut in the insulating blanket from corner to corner of each access panel.
  7. Fold the triangular flaps produced by the cuts underneath the insulating blanket. Repeat steps 6 and 7 for the rating/instruction plate.
  8. The blanket must not be installed on a leaking tank.

Content (c) Online Access, Inc.
© Online-Access
Google Map of Upland Mechanical
 
 
Contact Information
 
Address:  1018 Kingston
Pikesville MD 21208
Phone:  (410) 415-5922
Hours:  Monday - Friday  | 8am - 4:30pm
Schedule An Appointment
Emergency Service
Available 24 Hours
365 Days A Year
 
 
Send Us a Message
 
 
 
Payment Options
 
For Furnace in Pikesville MD, we accept most major credit cards.
 
We accept check for Boiler repair service provided in Owings Mills MD.
We accept cash for Heating repair service provided in Baltimore MD.
 
Connect With Us
 
 
For Furnace repair in Pikesville MD, like us on Facebook!
For Furnace repair in Owings Mills MD, visit us on Google!
To schedule your Boiler installation in Baltimore MD, just email us!
 
Home   |   Email Us   |   Schedule Service   |   Get a Quote   |   Maintenance   |   Guarantees   |   Employment   |   Promotions   |   Search Site
Home   |   Email Us   |   Schedule Service
Get a Quote   |   Maintenance   |   Guarantees
Employment   |   Promotions   |   Search Site